
Grooved Butterfly Valve
The handle grooved butterfly valve is mainly used in the fire pipe, and the clamp butterfly valve is used in the ordinary pipe. The characteristics of the grooved handle butterfly valve: simple structure, simple operation, can be rotated by the handle or the turbine; Low price, the current valve body is a small valve body, mostly ductile iron material; The installation is simple, and the link between the valve and the pipeline requires a clamp, and does not require flanges and bolts. The grooved handle butterfly valve is mainly used in fire pipes, most of which have no practical application after completion, so they do not need to be replaced frequently.
Description
Ca-Fire Protection Co.,Ltd is one of the most credible manufacturers and suppliers of grooved butterfly valve in China. Welcome to wholesale custom made fire equipment products at competitive price from our factory. Contact us for more cheap products.
Grooved Butterfly Valve
The handle grooved butterfly valve is mainly used in the fire pipe, and the clamp butterfly valve is used in the ordinary pipe. The characteristics of the grooved handle butterfly valve: simple structure, simple operation, can be rotated by the handle or the turbine; Low price, the current valve body is a small valve body, mostly ductile iron material; The installation is simple, and the link between the valve and the pipeline requires a clamp, and does not require flanges and bolts. The grooved handle butterfly valve is mainly used in fire pipes, most of which have no practical application after completion, so they do not need to be replaced frequently.

When designing a fire handle grooved butterfly valve system, the following points need to be considered:
1. Sealing design of control valve. A single seat valve can achieve a leakage of less than 1 drop per hour. Two-seat valves are difficult to close tightly in both seats. Therefore, consider the possibility of switching to a single-seat valve.
2. The large amount of high pressure fluid accumulated between the cut-off valves may present considerable force, and serious personal accidents may occur if the operation of the control valve pressure is discharged carelessly.
3. Is the fluid a gas, a clean liquid, or a liquid with suspended solids?
Even good fire trench handle butterfly valve design, cut off will inevitably accumulate high pressure liquid. Therefore, it is recommended that if the potential energy of a few liquids is very dangerous, install a blowdown valve and a drain valve on each side of the control valve.
For the fire trench handle butterfly valve with a large amount of high pressure material accumulated, it is reasonable to consider installing two blow off valves and discharge valves. Only a small amount of material accumulates between the two fire handle groove butterfly valves, while gradually releasing the pressure of the system, so that the fluid pressure between the two discharge or blow-off valves is repeatedly accumulated and discharged. Note that the control valve is open during this process. If the fluid being discharged is a dangerous gas, the blowdown line is connected to a safe place.
If the gas is not flammable, it is still necessary to vent the line to avoid blowing out the gas to entrap rust or other substances that could harm the person handling the vent valve.
Hot Tags: grooved butterfly valve, China grooved butterfly valve manufacturers, suppliers, factory, Handle Wafer Butterfly Valve, Butterfly Valves
Send Inquiry
You Might Also Like






