Brass Upright Sprinkler

Brass Upright Sprinkler

The CA fire protection T-ZST Series , 5.6 K-factor, Upright (T-ZSTZ80) and Pendent (T-ZSTX80) Sprinklers described herein must be installed and maintained in compliance with this document, as well as with the applicable standards of local , in addition to the standards of any other authorities having jurisdiction.

Description

Ca-Fire Protection Co.,Ltd is one of the most credible manufacturers and suppliers of brass upright sprinkler in China. Welcome to wholesale custom made fire equipment products at competitive price from our factory. Contact us for more cheap products.

 

Brass Upright Sprinkler


Notice When Install Brass Upright Sprinkler

Do not install any bulb-type sprinkler if the bulb is cracked or there is a loss of liquid from the bulb. With the sprinkler held horizontally, a small air bubble should be present. The diameter of the air bubble is approximately 1/16 in. (1,6 mm) for the 135°F (57°C) and 3/32 in. (2,4 mm) for the 286°F (141°C) temperature ratings.Do not attempt to compensate for insufficient adjustment in the Escutcheon Plate by under- or over-tightening the sprinkler. Re-adjust the position of the sprinkler fitting to suit.

product-523-361

Notes: Pendent sprinklers are to be installed in the pendent position; upright sprinklers are to be installed in the upright position.
Step 1. With pipe thread sealant applied to the pipe threads, handtighten the sprinkler into the sprinkler fitting.
Step 2. Tighten the sprinkler into the sprinkler fitting using only the W-Type 3 Sprinkler Wrench (Ref. Figure 1), except that an 8 in. or 10 in. adjustable wrench is to be used for wax-coated sprinklers. With reference to Figure 1, the W-Type 3 Sprinkler Wrench or the adjustable wrench, as applicable, is to be applied to the wrench flats.

Hot Tags: brass upright sprinkler, China brass upright sprinkler manufacturers, suppliers, factory, Pendent Standard Fire Sprinkler

You Might Also Like

Shopping Bags